AT&T Telephone DS1/DMi/ISDN-PRI Instrukcja Użytkownika Pobierz pdf (Strona 121)

100

101

SYNCHRONIZATION OF DIGITAL FACILITIES

5-31

The slip count provided by the interface should also be used in the process of choosing a healthy

clock reference. However, when the interface terminates on a D4-channel bank (or equivalent) that

is not locked to the AT&T reference frequency for its timing, then the interface should not be used

for synchronization.

Line-Only Mode DS1/DMI-BOS (TN767)

When using a line-only mode interface for synchronization purposes, the following facts should be

known:

●

Since the D4-channel bank (or equivalent) at the far end will be timed to the signal received from

a DS1/DMI, no slips should occur on a line-only mode DS1/DMI facility. Because of this, slip

counts from line-only mode DS1/DMI should not be used in the process of determining the health

of a clock reference (that is, they would tend to make the reference appear to be in better

condition than it may be).

Line-only mode DS1/DMI should not be used as system clock references unless it is known for

certain that the incoming DS1/DMI signal is locked to the AT&T reference frequency. Normally,

a DS1/DMI facility terminating directly on the far end D4-channel bank will not be locked to the

AT&T reference frequency.

Trunk-Mode DS1/DMI-MOS (TN767)

For Generic 1, DS1/DMI-MOS (TN767) will only terminate at a compatible computer. The

computer must always obtain its timing from the switch. The switch should never select the DMI-

MOS link as a timing reference.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 395 396

Komentarze do niniejszej Instrukcji

Brak uwag

AT&T Telephone DS1/DMi/ISDN-PRI Instrukcja Użytkownika Strona 121

Komentarze do niniejszej Instrukcji